The easiet way to make one of these

[timbowens112]

http://www.ballbusting+++tube.com/vi...shed-testicles

any ideas? Suggestions on what to use?

[Leatherface]

Use lexan not plexiglass. Hinge it at the top, and put bolts at the bottom. Different ones use different sized spacers at the top between the hinges and the acrylic. Construction is pretty straight forward. A lot easier to make if you have access to a milling machine, but a drill press will work.

[v15]

http://www.ballbusting+++tube.com/vi...shed-testicles

any ideas? Suggestions on what to use?

Or you could just buy it, here try this link, see if it helps: http://www.fetishtoybox.com/Cock-and...her-FMO106.htm
Also there are 3 more ballcrusher toys on this page:
http://www.fetishtoybox.com/COCK-AND-BALL-TOYS_c19.htm

[skweezme]

My Mistress has now got one of these devices, I'm so looking forward to Her crushing my balls in it!

[timbowens112]

Hmmm. I'd like to buy one by I'd have to make sure I got the mail that day. Plus not to show off but 1.5 diameter cock hole? My dick is 6.5 inches around. It'd. Never fit unless I wasn't hard.

[curmudgeon]

I don't think you are really meant to try to have sex with the thing. You put it on flaccid and it will fit just fine.

[Alec Anaconda, A1]

Hmmm. I'd like to buy one by I'd have to make sure I got the mail that day. Plus not to show off but 1.5 diameter cock hole? My dick is 6.5 inches around. It'd. Never fit unless I wasn't hard.

I think you are wise to be concerned, for even if you start limp, a good erection is fully feasible.
Although the considerable discomfort of a 2 inch “diameter” cock constricted within a 1.5 inch diameter round hole might be a bonus, it’s trying to expand within just over half the space it needs.
I don’t see how the blood will drain back out, apart from sawing through the toy or getting a doctor to make an incision in your cock.